Hangyu Power Supply: GJB181B-2012 Aircraft Power Supply Characteristics Standard DC 28V Partial Test

2019-09-10 18:02

The standard for aircraft power supply characteristics is not only an important standard for the design of aircraft electrical systems, but also an interface standard between aircraft power supply systems and electrical equipment; It is a standard that should be implemented during the development, production, procurement, acceptance, use, maintenance, and repair process; It is the basis for domestic and international technical coordination and inspection and acceptance of imported equipment. The evolution of GJB181 is: GJB181-1986 → GJB181A-2003 → GJB181B-2012.


GJB181 has seven major power supply testing projects, among which Hangyu Power brings a dedicated testing power supply: HY-GJB series testing power supply for DC 28V power supply testing projects. This power supply is equipped with dedicated upper computer software, specifically designed for testing the steady-state and transient characteristics of the DC 28V system in GJB181B-2012. It can simulate the electrical environment of the aircraft power supply system in normal, conversion, abnormal, emergency, electrical startup, and power supply failure situations.


The HY·GJBSU series is a DC regulated power supply suitable for standard testing of 28V aircraft power supply characteristics in GJB 181B-2012. This power supply can generate any waveform and set timing control, using a "linear amplifier method" to achieve the functional advantages of low ripple, low noise, and high-speed response.


Output broadband: DC~10kHz/20kHz/50kHz/100kHz (CV mode)


Output voltage: maximum -100V~+100V


Output current: 0~± 500A


Output power: 200W~10kW


Low ripple/low noise


High speed response speed, voltage response time ≤ 10 μ S


Testable items


LDC103 voltage distortion spectrum measurement


This test is used to verify whether the DC 28V electrical equipment can operate normally and maintain its specified performance when the frequency and amplitude specified in the voltage distortion spectrum of GJB181B-2012 occur in the power supply voltage.


LDC104 pulsation measurement


This test is used to verify whether the DC 28V electrical equipment can operate normally and maintain the specified performance when the power supply voltage is fluctuating according to GJB181B-2012.


Figure LDC104-1 Typical Configuration of Pulsation Test System


This test is used to verify whether the DC 28V electrical equipment can operate normally and maintain the specified performance when the power supply voltage is fluctuating according to GJB181B-2012.